Audi RNS-E Installation Guide download pdf (Page 5)

Remove the center trim piece (1) between the

steering wheel column and instrument cluster

by pulling straight out.

The picture shows the steering wheel removed. It is

not necessary to remove the steering wheel for any

part of this installation.

Remove the driver’s side knee panel and set it out of the way. See the picture below.

Remove the two Phillips screws holding the bottom of the instrument cluster. These are likely to be

extremely tight. Use the proper size Phillips screwdriver. Reach up under the dash and push the

instrument cluster out from the rear. When the cluster is loose, remove it by pulling the left side out

first, unplugging the blue connector on the left rear, then the grey connector in the middle, then the

green connector on the right end. Each of these plugs has a small purple clamp that holds it in place.

Simply lift this purple clamp up and the plug will remove itself from the cluster. See next illustration.

1 2 3 4 5 6 7 8 9 10 ... 60 61

No comments

Audi RNS-E Installation Guide Page 5